Hip-to-Gable Loft Conversion Drawings in Feltham TW13
Fixed-fee, MCIAT-chartered hip-to-gable loft conversion drawings for Feltham (TW13) homeowners — London Borough of Hounslow validation and local constraints handled from the start.
Feltham is an outer-west Hounslow suburb built largely between the wars and in the post-war decades, so the bulk of our work here is family-driven: single-storey rear extensions, side-return infills and loft conversions on 1930s semis and estate housing. Wide plots on roads such as Southern Avenue and Ashmead Road usually leave comfortable room to extend under permitted development while keeping the front elevation intact.
Where a plot sits near the St Dunstan's or Hanworth Park conservation areas, or on the lower ground close to the River Crane, we design to Hounslow Council's expectations from the outset — matching brick and roof lines, respecting the depth and height limits, and building in flood-resilient drainage detail so the application clears validation without an avoidable refusal.
Planning in Feltham (TW13): what to know before you apply
There is no published householder Article 4 direction in Feltham, so most rear and loft projects proceed under permitted development. Watch the St Dunstan's, Hanworth Park and Feltham Town Centre conservation areas, and the flood constraint on plots near the River Crane, where PD rights and extension depths are more tightly read.
Typical Feltham housing stock
Feltham is dominated by 1930s bay-fronted semis and post-war council-built estates, with generous rear gardens on roads like Southern Avenue and Glebelands Road. Plots are wide enough for single-storey rear extensions, side infills and hip-to-gable loft conversions without needing to touch the front elevation.
Streets we regularly draw for in Feltham
Southern Avenue · Glebelands Road · Ashmead Road · Browells Lane
What TW13 is actually built of
Measured from 396 classified residential buildings in TW13, not from a description of the area.
Feltham TW13 housing mix
Residential building form across the TW13 postcode district, from 396 classified buildings.
| Attached on more than one side | 41% |
|---|---|
| Attached on one side | 54% |
| Detached | 5% |
| Median building footprint | 54 m² |
| Addresses per buildingAbove about 2 means flats and maisonettes dominate | 1.56 |
| Buildings classified | 396 |
Source: Ordnance Survey National Geographic Database (derived statistics). Contains OS data © Crown copyright and database right 2026. Contains Royal Mail data © Royal Mail copyright and database right 2026. Extracted 2026-08-17.
Hip-to-Gable Loft Conversion Drawings for Feltham (TW13) homes: the package and the process
The hip-to-gable case is made on the end elevation. The drawings show the existing hipped roof and the proposed gable side by side at the same scale, with the new brickwork or tile hanging set out, the ridge extended to its new length, and the junction with any neighbouring roof made explicit.
Because the work changes the roof at the boundary, the section and the end elevation also have to show the party wall line and how the new gable is built off it. Where the property is one of a pair, we draw the neighbouring roof too — an officer assessing the effect on the pair needs to see both.
The conversion needs a hip to work on, which limits it to semi-detached, detached and end-of-terrace houses — a mid-terrace has no hipped end to rebuild. On a semi, the new gable also has to be drawn against the neighbour's roof, since the pair was designed to read as one.
What is a hip-to-gable loft conversion?
A hipped roof slopes inward on all sides, including the end wall, rather than finishing in a flat vertical gable. A hip-to-gable conversion rebuilds that sloping hip as a vertical wall, in line with the existing side elevation below, squaring off the roof shape and creating a much larger, more usable loft footprint along that side without altering the rear or front roof slopes at all. It is one of the more straightforward roof alterations to build, because the new gable wall follows the line of the existing external wall rather than introducing a new roof form, which keeps both the design and the construction relatively contained compared with a full mansard rebuild.
- Suits semi-detached and end-of-terrace houses with a hipped roof on the side elevation
- Squares off the roof by rebuilding the sloping hip as a vertical gable wall
- Leaves the front and rear roof slopes untouched
Is a hip-to-gable loft conversion permitted development?
Often, yes. For semi-detached and detached houses, permitted development rules allow more than one hip to be converted to a gable, provided the new roof does not exceed the height of the existing ridge and the total additional volume stays within the usual allowance — 50 cubic metres for detached and semi-detached homes. The new gable wall and roof materials should match the existing building, and the rules tighten or disappear entirely inside a conservation area or under an Article 4 direction, both of which we check before recommending the route. Where a previous owner has already extended into the roof or added a large outbuilding, the remaining volume allowance can be smaller than expected, so we always confirm the running total against your specific property rather than assuming the full allowance is still available.
What is a hip-to-gable-plus-dormer conversion?
Combining a hip-to-gable conversion with a rear dormer is one of the most effective ways to maximise a loft on a semi-detached or end-of-terrace house: the gable squares off the side of the roof while the dormer adds headroom over the rear slope and stairwell, together often creating close to a full-width habitable floor. We assess both elements together from the first survey — see our dormer loft conversion page for how the rear element is designed — rather than drawing a hip-to-gable in isolation and bolting on a dormer later. Because both elements are often permitted development on their own, the combined scheme frequently still fits within the same volume allowance, though we always check the running total before confirming the route.
| Conversion | Typical route | Structural scope | Fee from |
|---|---|---|---|
| Hip-to-gable only | Permitted development / LDC | New gable wall and rafter tie-in | £1,300 |
| Hip-to-gable plus rear dormer | Permitted development / LDC where eligible | Gable wall plus dormer structure | £1,450 |
| Hip-to-gable in a conservation area | Householder planning | New gable wall and rafter tie-in | £1,600 |
Hip-to-Gable Loft Conversion Drawings in Feltham TW13 — FAQs
How much do hip-to-gable loft conversion drawings cost in London?+
Will my semi-detached house qualify for permitted development?+
How long do hip-to-gable drawings take?+
Do I need an architect for a hip-to-gable conversion?+
What building regulations apply to a hip-to-gable loft?+
Do I need planning permission for an extension in Hounslow?+
What extra control applies in Bedford Park?+
Does Heathrow or the river affect my Hounslow project?+
How long does Hounslow Council take to decide?+
How much do planning drawings cost in Hounslow?+
Get your free Feltham planning assessment
Tell us your Feltham (TW13) address and ambition — we'll confirm feasibility, local constraints and a fixed fee within one working day.