Hip-to-Gable Loft Conversion Drawings in Greenford UB6
Fixed-fee, MCIAT-chartered hip-to-gable loft conversion drawings for Greenford (UB6) homeowners — London Borough of Ealing validation and local constraints handled from the start.
Greenford (UB6) is classic outer-west-London Metro-land: broad avenues of interwar semis with deep gardens, ideal for rear and wraparound kitchen extensions, loft conversions with rear dormers, and garage-to-room conversions. Most householder projects here fall squarely within permitted development or a straightforward Ealing Council householder application.
The one sensitivity is the Canalside conservation area on the neighbourhood's north-west flank near the Grand Union, where materials and rear massing get closer scrutiny. We prepare drawings that hold the interwar building line and gap-to-boundary rhythm Ealing's officers expect, and flag any canal-edge or former-industrial plot early so ground and drainage issues are designed out.
Planning in Greenford (UB6): what to know before you apply
No published householder Article 4 direction in Greenford, so most extensions and lofts run under permitted development or a standard Ealing householder application. Properties bordering the Canalside conservation area lose some permitted-development rights, and rear/side extension depths are assessed against the neighbouring semis' building line.
Typical Greenford housing stock
Greenford is dominated by 1920s-30s bay-fronted semis and short terraces laid out along wide suburban avenues, many with generous rear gardens and original hipped roofs. Nearer the Grand Union Canal and the old Rockware/Lyon works, plots give way to former industrial land and later flat-roofed infill.
Streets we regularly draw for in Greenford
Oldfield Lane North · The Fairway · Costons Avenue · Rockware Avenue
What UB6 is actually built of
Measured from 299 classified residential buildings in UB6, not from a description of the area.
Greenford UB6 housing mix
Residential building form across the UB6 postcode district, from 299 classified buildings.
| Attached on more than one side | 44% |
|---|---|
| Attached on one side | 54% |
| Detached | 2% |
| Median building footprint | 62 m² |
| Addresses per buildingAbove about 2 means flats and maisonettes dominate | 1.52 |
| Buildings classified | 299 |
Source: Ordnance Survey National Geographic Database (derived statistics). Contains OS data © Crown copyright and database right 2026. Contains Royal Mail data © Royal Mail copyright and database right 2026. Extracted 2026-08-17.
Hip-to-Gable Loft Conversion Drawings for Greenford (UB6) homes: the package and the process
The hip-to-gable case is made on the end elevation. The drawings show the existing hipped roof and the proposed gable side by side at the same scale, with the new brickwork or tile hanging set out, the ridge extended to its new length, and the junction with any neighbouring roof made explicit.
Because the work changes the roof at the boundary, the section and the end elevation also have to show the party wall line and how the new gable is built off it. Where the property is one of a pair, we draw the neighbouring roof too — an officer assessing the effect on the pair needs to see both.
The conversion needs a hip to work on, which limits it to semi-detached, detached and end-of-terrace houses — a mid-terrace has no hipped end to rebuild. On a semi, the new gable also has to be drawn against the neighbour's roof, since the pair was designed to read as one.
What is a hip-to-gable loft conversion?
A hipped roof slopes inward on all sides, including the end wall, rather than finishing in a flat vertical gable. A hip-to-gable conversion rebuilds that sloping hip as a vertical wall, in line with the existing side elevation below, squaring off the roof shape and creating a much larger, more usable loft footprint along that side without altering the rear or front roof slopes at all. It is one of the more straightforward roof alterations to build, because the new gable wall follows the line of the existing external wall rather than introducing a new roof form, which keeps both the design and the construction relatively contained compared with a full mansard rebuild.
- Suits semi-detached and end-of-terrace houses with a hipped roof on the side elevation
- Squares off the roof by rebuilding the sloping hip as a vertical gable wall
- Leaves the front and rear roof slopes untouched
Is a hip-to-gable loft conversion permitted development?
Often, yes. For semi-detached and detached houses, permitted development rules allow more than one hip to be converted to a gable, provided the new roof does not exceed the height of the existing ridge and the total additional volume stays within the usual allowance — 50 cubic metres for detached and semi-detached homes. The new gable wall and roof materials should match the existing building, and the rules tighten or disappear entirely inside a conservation area or under an Article 4 direction, both of which we check before recommending the route. Where a previous owner has already extended into the roof or added a large outbuilding, the remaining volume allowance can be smaller than expected, so we always confirm the running total against your specific property rather than assuming the full allowance is still available.
What is a hip-to-gable-plus-dormer conversion?
Combining a hip-to-gable conversion with a rear dormer is one of the most effective ways to maximise a loft on a semi-detached or end-of-terrace house: the gable squares off the side of the roof while the dormer adds headroom over the rear slope and stairwell, together often creating close to a full-width habitable floor. We assess both elements together from the first survey — see our dormer loft conversion page for how the rear element is designed — rather than drawing a hip-to-gable in isolation and bolting on a dormer later. Because both elements are often permitted development on their own, the combined scheme frequently still fits within the same volume allowance, though we always check the running total before confirming the route.
| Conversion | Typical route | Structural scope | Fee from |
|---|---|---|---|
| Hip-to-gable only | Permitted development / LDC | New gable wall and rafter tie-in | £1,300 |
| Hip-to-gable plus rear dormer | Permitted development / LDC where eligible | Gable wall plus dormer structure | £1,450 |
| Hip-to-gable in a conservation area | Householder planning | New gable wall and rafter tie-in | £1,600 |
Hip-to-Gable Loft Conversion Drawings in Greenford UB6 — FAQs
How much do hip-to-gable loft conversion drawings cost in London?+
Will my semi-detached house qualify for permitted development?+
How long do hip-to-gable drawings take?+
Do I need an architect for a hip-to-gable conversion?+
What building regulations apply to a hip-to-gable loft?+
Do I need planning permission for a rear extension in Ealing?+
What extra control applies in Bedford Park?+
How long does Ealing Council take to decide a householder application?+
Can you help with a loft conversion on a 1930s Ealing semi?+
How much do planning drawings cost in Ealing?+
Get your free Greenford planning assessment
Tell us your Greenford (UB6) address and ambition — we'll confirm feasibility, local constraints and a fixed fee within one working day.