Rear kitchen extension interior for a 1930s semi in Sidcup DA14, London Borough of Bexley

Sidcup · DA14 · Bexley

Hip-to-Gable Loft Conversion Drawings in Sidcup DA14

Fixed-fee, MCIAT-chartered hip-to-gable loft conversion drawings for Sidcup (DA14) homeowners — London Borough of Bexley validation and local constraints handled from the start.

Sidcup's DA14 streets run from the 1930s semis of the Cray valley to the historic core of Foots Cray village, and most of our work here is rear kitchen extensions and loft conversions that add space to those bay-fronted family homes without losing garden depth.

If your home sits inside the Foots Cray Conservation Area the permitted-development shortcuts narrow, so we always confirm the boundary line first and then advise whether a project runs under permitted development or needs a full householder planning application to Bexley.

Proposed floor plan

Sidcup DA14

Sidcup (DA14) — planning at a glance

Council: London Borough of Bexley
Postcode district: DA14
Planning portal: View the Bexley planning portal
Housing stock: DA14 is dominated by 1930s bay-fronted semis and terraces along the Cray valley, wrapped around the older historic core of Foots Cray village where Victorian and Georgian buildings survive on the High Street. Larger detached and inter-war housing sits on the roads backing onto Foots Cray Meadows.
Article 4: No Article 4 direction is published for the DA14 part of Sidcup, so permitted-development rights apply outside the Foots Cray Conservation Area boundary.
Conservation: Foots Cray Conservation Area
Sample streets: High Street · Rectory Lane · Maidstone Road · Church Road
Local constraints: Foots Cray Conservation Area — rear and side extensions inside the boundary face tighter design scrutiny and lose some permitted-development flexibilityProperties backing onto the Grade II registered Foots Cray Meadows and the River Cray face setting and flood-risk checks on deeper rear extensionsMature TPO tree cover across the Cray valley means many DA14 gardens carry protected trees that constrain extension footprints and foundations

Planning in Sidcup (DA14): what to know before you apply

Most DA14 extensions and lofts outside the conservation area proceed under permitted development or a lawful development certificate. Inside the Foots Cray Conservation Area, or where a home backs onto Foots Cray Meadows or carries protected trees, a full householder planning application to Bexley is the safer route. We check the boundary and tree constraints before recommending either path.

Typical Sidcup housing stock

DA14 is dominated by 1930s bay-fronted semis and terraces along the Cray valley, wrapped around the older historic core of Foots Cray village where Victorian and Georgian buildings survive on the High Street. Larger detached and inter-war housing sits on the roads backing onto Foots Cray Meadows.

Streets we regularly draw for in Sidcup

High Street · Rectory Lane · Maidstone Road · Church Road

What DA14 is actually built of

Measured from 299 classified residential buildings in DA14, not from a description of the area.

Sidcup DA14 housing mix

Residential building form across the DA14 postcode district, from 299 classified buildings.

Attached on more than one side	34%
Attached on one side	53%
Detached	13%
Median building footprint	71 m²
Addresses per buildingAbove about 2 means flats and maisonettes dominate	1.25
Buildings classified	299

Source: Ordnance Survey National Geographic Database (derived statistics). Contains OS data © Crown copyright and database right 2026. Contains Royal Mail data © Royal Mail copyright and database right 2026. Extracted 2026-08-17.

Hip-to-Gable Loft Conversion Drawings for Sidcup (DA14) homes: the package and the process

The hip-to-gable case is made on the end elevation. The drawings show the existing hipped roof and the proposed gable side by side at the same scale, with the new brickwork or tile hanging set out, the ridge extended to its new length, and the junction with any neighbouring roof made explicit.

Because the work changes the roof at the boundary, the section and the end elevation also have to show the party wall line and how the new gable is built off it. Where the property is one of a pair, we draw the neighbouring roof too — an officer assessing the effect on the pair needs to see both.

The conversion needs a hip to work on, which limits it to semi-detached, detached and end-of-terrace houses — a mid-terrace has no hipped end to rebuild. On a semi, the new gable also has to be drawn against the neighbour's roof, since the pair was designed to read as one.

What is a hip-to-gable loft conversion?

A hipped roof slopes inward on all sides, including the end wall, rather than finishing in a flat vertical gable. A hip-to-gable conversion rebuilds that sloping hip as a vertical wall, in line with the existing side elevation below, squaring off the roof shape and creating a much larger, more usable loft footprint along that side without altering the rear or front roof slopes at all. It is one of the more straightforward roof alterations to build, because the new gable wall follows the line of the existing external wall rather than introducing a new roof form, which keeps both the design and the construction relatively contained compared with a full mansard rebuild.

Suits semi-detached and end-of-terrace houses with a hipped roof on the side elevation
Squares off the roof by rebuilding the sloping hip as a vertical gable wall
Leaves the front and rear roof slopes untouched

Is a hip-to-gable loft conversion permitted development?

Often, yes. For semi-detached and detached houses, permitted development rules allow more than one hip to be converted to a gable, provided the new roof does not exceed the height of the existing ridge and the total additional volume stays within the usual allowance — 50 cubic metres for detached and semi-detached homes. The new gable wall and roof materials should match the existing building, and the rules tighten or disappear entirely inside a conservation area or under an Article 4 direction, both of which we check before recommending the route. Where a previous owner has already extended into the roof or added a large outbuilding, the remaining volume allowance can be smaller than expected, so we always confirm the running total against your specific property rather than assuming the full allowance is still available.

What is a hip-to-gable-plus-dormer conversion?

Combining a hip-to-gable conversion with a rear dormer is one of the most effective ways to maximise a loft on a semi-detached or end-of-terrace house: the gable squares off the side of the roof while the dormer adds headroom over the rear slope and stairwell, together often creating close to a full-width habitable floor. We assess both elements together from the first survey — see our dormer loft conversion page for how the rear element is designed — rather than drawing a hip-to-gable in isolation and bolting on a dormer later. Because both elements are often permitted development on their own, the combined scheme frequently still fits within the same volume allowance, though we always check the running total before confirming the route.

Typical hip-to-gable loft conversion drawing packages
Conversion	Typical route	Structural scope	Fee from
Hip-to-gable only	Permitted development / LDC	New gable wall and rafter tie-in	£1,300
Hip-to-gable plus rear dormer	Permitted development / LDC where eligible	Gable wall plus dormer structure	£1,450
Hip-to-gable in a conservation area	Householder planning	New gable wall and rafter tie-in	£1,600

Sheet from a hip-to-gable loft conversion drawings package drawn for a Sidcup property in DA14, showing the existing and proposed arrangement at scale — A sheet from the hip-to-gable loft conversion drawings package we submit to London Borough of Bexley for Sidcup (DA14) properties.

Also in Sidcup DA14

Planning Permission Planning Drawings Architectural Drawings Building Regulations Drawings Loft Conversion Drawings Hip-to-Gable Loft Conversion Drawings across Bexley Hip-to-Gable Loft Conversion Drawings across London

FAQ

Hip-to-Gable Loft Conversion Drawings in Sidcup DA14 — FAQs

How much do hip-to-gable loft conversion drawings cost in London?+

A hip-to-gable conversion on its own typically starts around £1,300. Combining it with a rear dormer usually costs a little more, around £1,450, to cover the additional structural design — we confirm the fixed fee once we have surveyed your roof.

Will my semi-detached house qualify for permitted development?+

Often, but it depends on the volume already used, whether the property sits in a conservation area or under an Article 4 direction, and whether previous extensions have already used up the allowance. We check this free before recommending a route.

How long do hip-to-gable drawings take?+

Typically around 7 days from survey to a full drawing set in your online portal, whether the route is a Lawful Development Certificate or full planning.

Do I need an architect for a hip-to-gable conversion?+

No — as MCIAT-chartered architectural technologists we produce the same council-accepted drawings, with structural calculations coordinated in-house, typically at a lower fee than an architecture practice.

What building regulations apply to a hip-to-gable loft?+

The same core requirements as any loft conversion: a protected stairway or upgraded fire doors, a compliant means-of-escape window, structural calculations for the new gable wall and floor, and insulation upgraded to current Part L standards. We coordinate all of this alongside the planning or Lawful Development Certificate drawings.

Do I need planning permission for an extension in Bexley?+

Bexley has no borough-wide Article 4 direction affecting typical householder permitted development, so its semi-detached homes often keep fuller rights than inner-London terraces — larger rear and single-storey extensions can qualify. Conservation areas such as Old Bexley Village and Danson Park, and riverside flood-zone constraints toward Erith, restrict this. We check your address first and can confirm permitted development with a Lawful Development Certificate.

Can I build a bigger extension because Bexley plots are larger?+

Often, yes. The generous interwar plots across Bexleyheath, Sidcup and Welling make substantial rear and double-storey extensions viable where a tight terrace could not. The limit is usually design and amenity policy rather than space. We design to use the plot fully within permitted-development allowances or a well-evidenced full application.

What extra control applies in Old Bexley Village or around Danson Park?+

These conservation areas carry design control over materials, rooflines and front elevations, and the Upton area of Bexleyheath includes the setting of William Morris's Red House. Permitted development is often restricted there, so we design to the area's character and prepare a full, context-led application where a standard permitted-development route doesn't apply.

How long does Bexley Council take to decide?+

Bexley determines most householder applications within the statutory eight-week period once validated; conservation cases can involve additional consultation. A complete, correctly scaled submission is the best way to avoid a validation query — we prepare Bexley drawings to the council's checklist to keep the application on track.

How much do planning drawings cost in Bexley?+

We quote a fixed fee upfront, typically around 30% below an architect's charge for the same council-accepted drawings, with free redraws until Bexley approves. Because plots here allow larger schemes, the fee tracks complexity — a single-storey rear differs from a double-storey — and we confirm it once we understand your plans.

Free Fixed Quote

Get your free Sidcup planning assessment

Tell us your Sidcup (DA14) address and ambition — we'll confirm feasibility, local constraints and a fixed fee within one working day.