Rear extension behind a detached inter-war house in suburban Upminster RM14 in Havering

Upminster · RM14 · Havering

Side Return Extension Drawings in Upminster RM14

Fixed-fee, MCIAT-chartered side return extension drawings for Upminster (RM14) homeowners — London Borough of Havering validation and local constraints handled from the start.

Upminster (RM14) runs from a leafy Edwardian and inter-war suburb down to Corbets Tey, a surviving medieval village and one of the three settlements that originally formed Upminster. The Corbets Tey Conservation Area protects that village character, its listed buildings and its countryside-edge setting, so work there faces close conservation-area control.

Across the wider suburb the housing is mostly detached and semi-detached homes on good-sized plots, and rear extensions, side infills, loft conversions and garden rooms are the usual projects. Havering's householder guidance sets clear expectations, and matching them in the drawings is what gets RM14 schemes through first time.

Proposed floor plan

Upminster RM14

Upminster (RM14) — planning at a glance

Council: London Borough of Havering
Postcode district: RM14
Planning portal: View the Havering planning portal
Housing stock: The Corbets Tey village group of listed and historic buildings on the edge of open countryside, surrounded by the Edwardian and inter-war detached and semi-detached housing that makes up most of suburban Upminster.
Article 4: London Borough of Havering does not publish its Article 4 directions to the national planning register, so permitted development rights in Upminster (RM14) can’t be confirmed from open data alone — we check the direction schedule with the council before recommending a route, as part of the fixed fee. No borough-wide Article 4 direction covers RM14 householder work; the Corbets Tey conservation-area control is the defining constraint.
Conservation: Corbets Tey
Sample streets: Corbets Tey Road · Harwood Hall Lane · Ockendon Road · Hall Lane
Local constraints: Corbets Tey Conservation Area — one of the three medieval settlements that formed Upminster, protecting its village character, the listed grade II group south of Harwood Hall Lane and the countryside-edge settingElevated village junction of Ockendon Road, Harwood Hall Lane and Corbets Tey Road where new build lines and heights are sensitiveGreen-belt and open-countryside edge to the south limiting how far development can extend beyond the built village

Planning in Upminster (RM14): what to know before you apply

No borough-wide Article 4 direction affects typical RM14 householder work, so many Upminster houses retain permitted development rights for rear and loft projects. The exception is the Corbets Tey Conservation Area, where the village character, listed group and countryside-edge setting mean external changes are controlled and permitted development is curtailed.

Typical Upminster housing stock

The Corbets Tey village group of listed and historic buildings on the edge of open countryside, surrounded by the Edwardian and inter-war detached and semi-detached housing that makes up most of suburban Upminster.

Streets we regularly draw for in Upminster

Corbets Tey Road · Harwood Hall Lane · Ockendon Road · Hall Lane

What RM14 is actually built of

Measured from 294 classified residential buildings in RM14, not from a description of the area.

Upminster RM14 housing mix

Residential building form across the RM14 postcode district, from 294 classified buildings.

Attached on more than one side	25%
Attached on one side	58%
Detached	17%
Median building footprint	82 m²
Addresses per buildingAbove about 2 means flats and maisonettes dominate	1.14
Buildings classified	294

Source: Ordnance Survey National Geographic Database (derived statistics). Contains OS data © Crown copyright and database right 2026. Contains Royal Mail data © Royal Mail copyright and database right 2026. Extracted 2026-08-17.

Side Return Extension Drawings for Upminster (RM14) homes: the package and the process

A side return is a structural drawing as much as a planning one. Removing the original flank wall to open the kitchen into the infill needs a beam and a padstone detail, and the new roof has to be drawn where it meets both the existing rear elevation and the boundary wall.

The boundary is the sensitive line. The drawings set out where the new wall sits relative to it, how the roof drains without discharging next door, and where rooflights fall so the officer can see the room is lit without overlooking. That detail is also what your party wall surveyor will ask for.

The extension only exists where the alley does. Mid-terrace and end-of-terrace houses with a rear outrigger are the classic case; a semi with a flank path is a different scheme with different boundary questions; and a detached house has no side return to infill at all.

Do I need planning permission for a side return extension in London?

Permitted development rights for side extensions are narrower than for rear extensions: they generally cap the extension at a single storey, restrict its width to no more than half the width of the original house, and limit its height. In practice, a full-depth side return running the length of a Victorian or Edwardian terrace usually exceeds one or more of these limits, so most side return projects are drawn and submitted as a full householder planning application.

Conservation area status and Article 4 directions, common across inner London terraces, remove permitted development rights for side extensions entirely in many streets, reinforcing the need for a planning application. We check your property's status before drawing.

What does a side return extension involve?

A side return infills the alley at ground floor level, structurally opening the original flank wall of the kitchen into the new space so the two areas read as one room. Unlike a rear extension, which is bounded on three sides by your own garden, a side return is bounded on one long side by the neighbouring property, which shapes almost every decision in the design, from where the roof glazing sits to how deep the new foundations need to go.

New flank wall built out to align with the rear of the house, following the boundary line
Original external wall between kitchen and alley opened up and supported on a steel or glulam beam
Roof over the new space either glazed in full, glazed in a strip along the boundary for a 'light well' effect, or pitched and tiled to match the main roof
Kitchen re-planned across the combined footprint, often incorporating an island once the room widens

Will I need a Party Wall Agreement for a side return extension?

Almost certainly. Because the new side wall is built on or immediately against the boundary with the neighbouring property, the Party Wall etc. Act 1996 applies, and your neighbour must be formally notified before work starts. We prepare the drawings and dimensions your Party Wall surveyor needs, and time the notice period so it runs alongside, rather than after, your planning application.

Side return project options
Package	What it covers	Typical fee
Side return, planning only	Full householder planning application drawings for the infill	Full Planning pack ~£1,600–£2,400
Side return, planning + Building Regulations	Adds structural calculations, Party Wall drawings and construction detail	Planning + Building Regs pack ~£2,200–£3,850
Side return + rear extension (wraparound)	Combines both extensions into one L-shaped ground floor	see Wraparound Extension Drawings
Measured survey only	A measured existing floor-plan set for your own architect, surveyor or builder	from £450

Sheet from a side return extension drawings package drawn for a Upminster property in RM14, showing the existing and proposed arrangement at scale — A sheet from the side return extension drawings package we submit to London Borough of Havering for Upminster (RM14) properties.

Also in Upminster RM14

Planning Permission Planning Drawings Architectural Drawings Building Regulations Drawings Loft Conversion Drawings Side Return Extension Drawings across Havering Side Return Extension Drawings across London

FAQ

Side Return Extension Drawings in Upminster RM14 — FAQs

How much does a side return extension cost to design in London?+

Side return drawings start from £1,400. The final fee depends on whether you commission planning drawings alone or a combined planning and building regulations package with structural calculations, all fixed and agreed upfront.

Can I build a side return under permitted development?+

Rarely for a full-width, full-depth side return. Permitted development for side extensions is limited on width and storeys, and most Victorian and Edwardian terraces sit in conservation areas that remove these rights anyway, so a full planning application is the usual route. We still check your specific property first, since some semi-detached and detached houses outside conservation areas retain more generous side-extension allowances.

When do I need to serve Party Wall notice on my neighbour?+

Before work starts, and ideally once your drawings and structural design are settled, since the notice needs accurate dimensions. We can prepare the supporting drawings alongside your planning application so both processes run in parallel.

Do I need an architect for a side return extension?+

No. DrawingsDirect is an MCIAT-chartered architectural technologist practice, so you get the same council-accepted drawings as an architect, for a fixed fee typically around 30% lower, with structural calculations produced in-house.

How long does a side return extension take to design and approve?+

Drawings are typically ready around 7 days from survey. A householder planning application then has a statutory 8-week determination period, running alongside your Party Wall notice period.

Do I need planning permission for an extension in Havering?+

Havering has no borough-wide Article 4 direction affecting typical householder permitted development, so its detached and semi-detached homes often keep fuller rights than inner-London terraces — larger rear and single-storey extensions can qualify. Green-belt land toward the east and conservation areas such as Upminster and Emerson Park restrict this. We check your address first and can confirm permitted development with a Lawful Development Certificate.

How does green-belt land affect my Havering project?+

On green-belt properties toward the borough's eastern and northern edges, extensions are assessed against strict limits on disproportionate additions to the original dwelling. It does not rule out an extension, but scale and siting matter and the case must be evidenced carefully. We confirm whether your property is green belt and design a scheme that stays within policy.

Can I build a bigger extension because Havering plots are larger?+

Often, yes. The generous interwar and detached plots across Hornchurch, Emerson Park and Upminster make substantial rear and double-storey extensions viable where a tight terrace could not. The limit is usually policy rather than space. We design to use the plot fully within permitted-development allowances or a well-evidenced full application.

How long does Havering Council take to decide?+

Havering determines most householder applications within the statutory eight-week period once validated; green-belt and conservation cases can involve additional consultation. A complete, correctly scaled submission is the best way to avoid a validation query — we prepare Havering drawings to the council's checklist to keep the application on track.

How much do planning drawings cost in Havering?+

We quote a fixed fee upfront, typically around 30% below an architect's charge for the same council-accepted drawings, with free redraws until Havering approves. Because plots here allow larger schemes, the fee tracks complexity — a single-storey rear differs from a double-storey or a green-belt case — and we confirm it once we understand your plans.

Free Fixed Quote

Get your free Upminster planning assessment

Tell us your Upminster (RM14) address and ambition — we'll confirm feasibility, local constraints and a fixed fee within one working day.