Kitchen extension inside a Georgian townhouse near Kew Green in Richmond TW9, London Borough of Richmond upon Thames

Richmond · TW9 · Richmond

Hip-to-Gable Loft Conversion Drawings in Richmond TW9

Fixed-fee, MCIAT-chartered hip-to-gable loft conversion drawings for Richmond (TW9) homeowners — London Borough of Richmond upon Thames validation and local constraints handled from the start.

Richmond (TW9) spans the town centre and the Kew border, layering conservation areas including Kew Green, Richmond Green, Central Richmond and Lawn Crescent across its Georgian and Victorian streets.

The Kew Green conservation area, with the Thames Path running past St Anne's churchyard and Kew Pond, protects 18th-century cottages such as Cambridge Cottages, which carry their own Article 4 direction.

Proposed floor plan

Richmond TW9

Richmond (TW9) — planning at a glance

Council: London Borough of Richmond upon Thames
Postcode district: TW9
Planning portal: View the Richmond planning portal
Housing stock: Georgian yellow-brick cottages and townhouses around Kew Green and Richmond Green, with later Victorian and Edwardian terraces filling out the Kew Gardens and Lawn Crescent streets.
Article 4: Cambridge Cottages in Kew and the wider Kew Green conservation area carry Article 4 directions, so extensions, replacement windows and doors, painting or rendering brickwork, removing chimneys and hard-surfacing front gardens need planning permission where they would otherwise be permitted development.
Conservation: Kew GreenRichmond GreenCentral RichmondLawn Crescent, KewKew Gardens
Sample streets: Kew Green · Cambridge Cottages · Lawn Crescent · Kew Foot Road · George Street · Kew Road
Local constraints: Article 4 directions on Cambridge Cottages and the Kew Green conservation area remove permitted-development rights, so shared original features across the terraces stay under planning control.The 18th-century cottages around Kew Green retain a high proportion of original detail — exposed timber sash frames and yellow stock brick — that the council resists altering.Central Richmond's conservation area runs along the George Street, Hill Street and Kew Road frontages, where the tight town-centre grain limits the scope for visible extensions.

Planning in Richmond (TW9): what to know before you apply

TW9 houses commonly sit inside the Kew Green, Richmond Green or Central Richmond conservation areas, and streets like Cambridge Cottages carry Article 4 directions — plan for front elevations, windows and roofs to need full planning permission rather than permitted development.

Typical Richmond housing stock

Georgian yellow-brick cottages and townhouses around Kew Green and Richmond Green, with later Victorian and Edwardian terraces filling out the Kew Gardens and Lawn Crescent streets.

Streets we regularly draw for in Richmond

Kew Green · Cambridge Cottages · Lawn Crescent · Kew Foot Road · George Street · Kew Road

What TW9 is actually built of

Measured from 349 classified residential buildings in TW9, not from a description of the area.

Richmond TW9 housing mix

Residential building form across the TW9 postcode district, from 349 classified buildings.

Attached on more than one side	47%
Attached on one side	42%
Detached	10%
Median building footprint	71 m²
Addresses per buildingAbove about 2 means flats and maisonettes dominate	1.67
Buildings classified	349

Source: Ordnance Survey National Geographic Database (derived statistics). Contains OS data © Crown copyright and database right 2026. Contains Royal Mail data © Royal Mail copyright and database right 2026. Extracted 2026-08-17.

Hip-to-Gable Loft Conversion Drawings for Richmond (TW9) homes: the package and the process

The hip-to-gable case is made on the end elevation. The drawings show the existing hipped roof and the proposed gable side by side at the same scale, with the new brickwork or tile hanging set out, the ridge extended to its new length, and the junction with any neighbouring roof made explicit.

Because the work changes the roof at the boundary, the section and the end elevation also have to show the party wall line and how the new gable is built off it. Where the property is one of a pair, we draw the neighbouring roof too — an officer assessing the effect on the pair needs to see both.

The conversion needs a hip to work on, which limits it to semi-detached, detached and end-of-terrace houses — a mid-terrace has no hipped end to rebuild. On a semi, the new gable also has to be drawn against the neighbour's roof, since the pair was designed to read as one.

What is a hip-to-gable loft conversion?

A hipped roof slopes inward on all sides, including the end wall, rather than finishing in a flat vertical gable. A hip-to-gable conversion rebuilds that sloping hip as a vertical wall, in line with the existing side elevation below, squaring off the roof shape and creating a much larger, more usable loft footprint along that side without altering the rear or front roof slopes at all. It is one of the more straightforward roof alterations to build, because the new gable wall follows the line of the existing external wall rather than introducing a new roof form, which keeps both the design and the construction relatively contained compared with a full mansard rebuild.

Suits semi-detached and end-of-terrace houses with a hipped roof on the side elevation
Squares off the roof by rebuilding the sloping hip as a vertical gable wall
Leaves the front and rear roof slopes untouched

Is a hip-to-gable loft conversion permitted development?

Often, yes. For semi-detached and detached houses, permitted development rules allow more than one hip to be converted to a gable, provided the new roof does not exceed the height of the existing ridge and the total additional volume stays within the usual allowance — 50 cubic metres for detached and semi-detached homes. The new gable wall and roof materials should match the existing building, and the rules tighten or disappear entirely inside a conservation area or under an Article 4 direction, both of which we check before recommending the route. Where a previous owner has already extended into the roof or added a large outbuilding, the remaining volume allowance can be smaller than expected, so we always confirm the running total against your specific property rather than assuming the full allowance is still available.

What is a hip-to-gable-plus-dormer conversion?

Combining a hip-to-gable conversion with a rear dormer is one of the most effective ways to maximise a loft on a semi-detached or end-of-terrace house: the gable squares off the side of the roof while the dormer adds headroom over the rear slope and stairwell, together often creating close to a full-width habitable floor. We assess both elements together from the first survey — see our dormer loft conversion page for how the rear element is designed — rather than drawing a hip-to-gable in isolation and bolting on a dormer later. Because both elements are often permitted development on their own, the combined scheme frequently still fits within the same volume allowance, though we always check the running total before confirming the route.

Typical hip-to-gable loft conversion drawing packages
Conversion	Typical route	Structural scope	Fee from
Hip-to-gable only	Permitted development / LDC	New gable wall and rafter tie-in	£1,300
Hip-to-gable plus rear dormer	Permitted development / LDC where eligible	Gable wall plus dormer structure	£1,450
Hip-to-gable in a conservation area	Householder planning	New gable wall and rafter tie-in	£1,600

Sheet from a hip-to-gable loft conversion drawings package drawn for a Richmond property in TW9, showing the existing and proposed arrangement at scale — A sheet from the hip-to-gable loft conversion drawings package we submit to London Borough of Richmond upon Thames for Richmond (TW9) properties.

Also in Richmond TW9

Planning Permission Planning Drawings Architectural Drawings Building Regulations Drawings Loft Conversion Drawings Hip-to-Gable Loft Conversion Drawings across Richmond Hip-to-Gable Loft Conversion Drawings across London

FAQ

Hip-to-Gable Loft Conversion Drawings in Richmond TW9 — FAQs

How much do hip-to-gable loft conversion drawings cost in London?+

A hip-to-gable conversion on its own typically starts around £1,300. Combining it with a rear dormer usually costs a little more, around £1,450, to cover the additional structural design — we confirm the fixed fee once we have surveyed your roof.

Will my semi-detached house qualify for permitted development?+

Often, but it depends on the volume already used, whether the property sits in a conservation area or under an Article 4 direction, and whether previous extensions have already used up the allowance. We check this free before recommending a route.

How long do hip-to-gable drawings take?+

Typically around 7 days from survey to a full drawing set in your online portal, whether the route is a Lawful Development Certificate or full planning.

Do I need an architect for a hip-to-gable conversion?+

No — as MCIAT-chartered architectural technologists we produce the same council-accepted drawings, with structural calculations coordinated in-house, typically at a lower fee than an architecture practice.

What building regulations apply to a hip-to-gable loft?+

The same core requirements as any loft conversion: a protected stairway or upgraded fire doors, a compliant means-of-escape window, structural calculations for the new gable wall and floor, and insulation upgraded to current Part L standards. We coordinate all of this alongside the planning or Lawful Development Certificate drawings.

Do I need planning permission for an extension in Richmond?+

More often than in most boroughs, yes. Richmond has some of the most extensive Article 4 coverage in London, so permitted development cannot be assumed even for modest works — many conservation areas such as Richmond Green, Teddington and Kew Green require a full application. We confirm the exact designation for your address first and design accordingly rather than relying on permitted development.

My Richmond home is near the river — does flood risk affect my application?+

It can. Much of the borough lies within the Thames flood zone, and the council expects flood-risk considerations to be addressed for works near the river in Twickenham, Richmond and Hampton. We evidence flood-risk and finished-floor-level considerations within the application so the council can validate and approve without repeated revisions.

What does Richmond's Article 4 coverage mean in practice?+

Article 4 directions remove permitted development rights across many of Richmond's conservation areas, so alterations that would be automatic elsewhere — dormers, cladding, some rear works — need a full householder application here. We design context-led drawings that respond to the borough's period townscape and river frontage, which is what carries an application to consent in Richmond.

How long does Richmond Council take to decide?+

Richmond determines most householder applications within the statutory eight-week period once validated, though conservation and riverside cases can attract additional consultation. Because so much turns on design detail here, we prepare submissions to the validation checklist with the elevations and materials the council expects, to avoid drawing queries.

How much do planning drawings cost in Richmond?+

We agree a fixed fee before starting, typically around 30% below an architect's fee for the same council-accepted drawings, with free redraws until Richmond approves. Conservation and flood-zone cases require more evidence than a standard extension, so we quote once we understand your address and scheme rather than by the hour.

Free Fixed Quote

Get your free Richmond planning assessment

Tell us your Richmond (TW9) address and ambition — we'll confirm feasibility, local constraints and a fixed fee within one working day.