Hip-to-Gable Loft Conversion Drawings in Kentish Town NW5
Fixed-fee, MCIAT-chartered hip-to-gable loft conversion drawings for Kentish Town (NW5) homeowners — London Borough of Camden validation and local constraints handled from the start.
Kentish Town (NW5) is predominantly Victorian, with two conservation areas — Dartmouth Park on the rising ground to the north and Inkerman in the streets off Kentish Town Road — and Camden's Article 4 layer over the top. It is a district where the difference between one street and the next genuinely changes the route to consent.
Camden's Basements direction removes permitted development rights for basement works throughout, so lower-ground schemes need a full application. The Class E to C3 direction, in its outside-the-CAZ form, removes the permitted commercial-to-residential change here — which matters along Kentish Town Road and Fortess Road, where the shop-to-flat conversion is a common project and now needs planning rather than prior approval. In the Dartmouth Park and Inkerman conservation areas, frontages and rooflines are controlled, and the rise toward Dartmouth Park Hill means rear extension levels and overlooking are assessed against the slope. We check the boundaries and the Article 4 position for an NW5 address before drawing to Camden's guidance.
Planning in Kentish Town (NW5): what to know before you apply
NW5 falls under Camden's Basements Article 4 direction, removing permitted development rights for basement works, and the outside-CAZ Class E to C3 direction, which removes the permitted commercial-to-residential change — so shop-to-flat conversions along Kentish Town Road and Fortess Road need full planning applications rather than prior approval. The Dartmouth Park and Inkerman conservation areas control frontages and rooflines, and the rising ground toward Dartmouth Park Hill brings level and overlooking assessments into rear extension design.
Typical Kentish Town housing stock
Victorian terraces through the centre and along Fortess Road, larger Victorian semi-detached and terraced houses climbing Dartmouth Park Hill, and a substantial share of the stock converted to flats.
Streets we regularly draw for in Kentish Town
Kentish Town Road · Fortess Road · Dartmouth Park Hill · Lady Margaret Road
What NW5 is actually built of
Measured from 371 classified residential buildings in NW5, not from a description of the area.
Kentish Town NW5 housing mix
Residential building form across the NW5 postcode district, from 371 classified buildings.
| Attached on more than one side | 68% |
|---|---|
| Attached on one side | 27% |
| Detached | 5% |
| Median building footprint | 66 m² |
| Addresses per buildingAbove about 2 means flats and maisonettes dominate | 2.43 |
| Buildings classified | 371 |
Source: Ordnance Survey National Geographic Database (derived statistics). Contains OS data © Crown copyright and database right 2026. Contains Royal Mail data © Royal Mail copyright and database right 2026. Extracted 2026-08-17.
Hip-to-Gable Loft Conversion Drawings for Kentish Town (NW5) homes: the package and the process
The hip-to-gable case is made on the end elevation. The drawings show the existing hipped roof and the proposed gable side by side at the same scale, with the new brickwork or tile hanging set out, the ridge extended to its new length, and the junction with any neighbouring roof made explicit.
Because the work changes the roof at the boundary, the section and the end elevation also have to show the party wall line and how the new gable is built off it. Where the property is one of a pair, we draw the neighbouring roof too — an officer assessing the effect on the pair needs to see both.
The conversion needs a hip to work on, which limits it to semi-detached, detached and end-of-terrace houses — a mid-terrace has no hipped end to rebuild. On a semi, the new gable also has to be drawn against the neighbour's roof, since the pair was designed to read as one.
What is a hip-to-gable loft conversion?
A hipped roof slopes inward on all sides, including the end wall, rather than finishing in a flat vertical gable. A hip-to-gable conversion rebuilds that sloping hip as a vertical wall, in line with the existing side elevation below, squaring off the roof shape and creating a much larger, more usable loft footprint along that side without altering the rear or front roof slopes at all. It is one of the more straightforward roof alterations to build, because the new gable wall follows the line of the existing external wall rather than introducing a new roof form, which keeps both the design and the construction relatively contained compared with a full mansard rebuild.
- Suits semi-detached and end-of-terrace houses with a hipped roof on the side elevation
- Squares off the roof by rebuilding the sloping hip as a vertical gable wall
- Leaves the front and rear roof slopes untouched
Is a hip-to-gable loft conversion permitted development?
Often, yes. For semi-detached and detached houses, permitted development rules allow more than one hip to be converted to a gable, provided the new roof does not exceed the height of the existing ridge and the total additional volume stays within the usual allowance — 50 cubic metres for detached and semi-detached homes. The new gable wall and roof materials should match the existing building, and the rules tighten or disappear entirely inside a conservation area or under an Article 4 direction, both of which we check before recommending the route. Where a previous owner has already extended into the roof or added a large outbuilding, the remaining volume allowance can be smaller than expected, so we always confirm the running total against your specific property rather than assuming the full allowance is still available.
What is a hip-to-gable-plus-dormer conversion?
Combining a hip-to-gable conversion with a rear dormer is one of the most effective ways to maximise a loft on a semi-detached or end-of-terrace house: the gable squares off the side of the roof while the dormer adds headroom over the rear slope and stairwell, together often creating close to a full-width habitable floor. We assess both elements together from the first survey — see our dormer loft conversion page for how the rear element is designed — rather than drawing a hip-to-gable in isolation and bolting on a dormer later. Because both elements are often permitted development on their own, the combined scheme frequently still fits within the same volume allowance, though we always check the running total before confirming the route.
| Conversion | Typical route | Structural scope | Fee from |
|---|---|---|---|
| Hip-to-gable only | Permitted development / LDC | New gable wall and rafter tie-in | £1,300 |
| Hip-to-gable plus rear dormer | Permitted development / LDC where eligible | Gable wall plus dormer structure | £1,450 |
| Hip-to-gable in a conservation area | Householder planning | New gable wall and rafter tie-in | £1,600 |
Hip-to-Gable Loft Conversion Drawings in Kentish Town NW5 — FAQs
How much do hip-to-gable loft conversion drawings cost in London?+
Will my semi-detached house qualify for permitted development?+
How long do hip-to-gable drawings take?+
Do I need an architect for a hip-to-gable conversion?+
What building regulations apply to a hip-to-gable loft?+
Do I need planning permission for a rear extension in Camden?+
What is a Basement Impact Assessment and will I need one in Camden?+
Can I make changes to a listed building in Camden?+
How long does Camden take to decide an application?+
How much do planning drawings cost in Camden?+
Get your free Kentish Town planning assessment
Tell us your Kentish Town (NW5) address and ambition — we'll confirm feasibility, local constraints and a fixed fee within one working day.