Rear extension on an interwar semi in Greenford UB6, planning drawings for Ealing Council approval

Greenford · UB6 · Ealing

Hip-to-Gable Loft Conversion Drawings in Greenford UB6

Fixed-fee, MCIAT-chartered hip-to-gable loft conversion drawings for Greenford (UB6) homeowners — London Borough of Ealing validation and local constraints handled from the start.

Greenford (UB6) is classic outer-west-London Metro-land: broad avenues of interwar semis with deep gardens, ideal for rear and wraparound kitchen extensions, loft conversions with rear dormers, and garage-to-room conversions. Most householder projects here fall squarely within permitted development or a straightforward Ealing Council householder application.

The one sensitivity is the Canalside conservation area on the neighbourhood's north-west flank near the Grand Union, where materials and rear massing get closer scrutiny. We prepare drawings that hold the interwar building line and gap-to-boundary rhythm Ealing's officers expect, and flag any canal-edge or former-industrial plot early so ground and drainage issues are designed out.

Proposed floor plan

Greenford UB6

Greenford (UB6) — planning at a glance

Council: London Borough of Ealing
Postcode district: UB6
Planning portal: View the Ealing planning portal
Housing stock: Greenford is dominated by 1920s-30s bay-fronted semis and short terraces laid out along wide suburban avenues, many with generous rear gardens and original hipped roofs. Nearer the Grand Union Canal and the old Rockware/Lyon works, plots give way to former industrial land and later flat-roofed infill.
Article 4: London Borough of Ealing does not publish its Article 4 directions to the national planning register, so permitted development rights in Greenford (UB6) can’t be confirmed from open data alone — we check the direction schedule with the council before recommending a route, as part of the fixed fee. No published householder Article 4 in Greenford; the main control is the canalside conservation area to the north-west and the industrial fringe along the Grand Union
Conservation: Canalside (north-west part)
Sample streets: Oldfield Lane North · The Fairway · Costons Avenue · Rockware Avenue
Local constraints: Canalside conservation-area control on the north-west edge affecting works visible from the Grand Union corridorInterwar semis where side-return and rear extensions must respect the established building line and gaps between pairsIndustrial and former-works land near the canal carrying potential contamination and drainage considerationsMature street trees on avenues such as The Fairway that may be TPO-protected

Planning in Greenford (UB6): what to know before you apply

No published householder Article 4 direction in Greenford, so most extensions and lofts run under permitted development or a standard Ealing householder application. Properties bordering the Canalside conservation area lose some permitted-development rights, and rear/side extension depths are assessed against the neighbouring semis' building line.

Typical Greenford housing stock

Greenford is dominated by 1920s-30s bay-fronted semis and short terraces laid out along wide suburban avenues, many with generous rear gardens and original hipped roofs. Nearer the Grand Union Canal and the old Rockware/Lyon works, plots give way to former industrial land and later flat-roofed infill.

Streets we regularly draw for in Greenford

Oldfield Lane North · The Fairway · Costons Avenue · Rockware Avenue

Hip-to-Gable Loft Conversion Drawings for Greenford (UB6) homes: the package and the process

Every hip-to-gable loft conversion drawings we prepare for an Greenford property is drawn to London Borough of Ealing’s validation standards and tuned to the UB6 constraints above. Here is what the drawing package covers and how the process runs from first survey to approval.

Many London semi-detached and end-of-terrace houses, particularly the inter-war suburban stock that rings much of the city, were built with a hipped roof — sloped on all sides rather than finished with a flat gable end. That side slope wastes usable loft volume, and a hip-to-gable conversion reclaims it by extending the sloping hip out to a full vertical gable wall, squaring off the roof and opening up far more headroom along that side of the loft than the original roof shape allowed.

DrawingsDirect draws hip-to-gable conversions across outer and suburban London every week, usually alongside a rear dormer to maximise headroom over the stairwell. Because the hip-to-gable route is frequently permitted development, we check your eligibility first — and where a dormer, a mansard or a combination would use your roof better, we say so before you commit to a design. Every drawing set is produced by MCIAT-chartered architectural technologists, with structural calculations for the new gable wall coordinated in-house rather than farmed out to a separate engineer.

What is a hip-to-gable loft conversion?

A hipped roof slopes inward on all sides, including the end wall, rather than finishing in a flat vertical gable. A hip-to-gable conversion rebuilds that sloping hip as a vertical wall, in line with the existing side elevation below, squaring off the roof shape and creating a much larger, more usable loft footprint along that side without altering the rear or front roof slopes at all. It is one of the more straightforward roof alterations to build, because the new gable wall follows the line of the existing external wall rather than introducing a new roof form, which keeps both the design and the construction relatively contained compared with a full mansard rebuild.

Suits semi-detached and end-of-terrace houses with a hipped roof on the side elevation
Squares off the roof by rebuilding the sloping hip as a vertical gable wall
Leaves the front and rear roof slopes untouched

Is a hip-to-gable loft conversion permitted development?

Often, yes. For semi-detached and detached houses, permitted development rules allow more than one hip to be converted to a gable, provided the new roof does not exceed the height of the existing ridge and the total additional volume stays within the usual allowance — 50 cubic metres for detached and semi-detached homes. The new gable wall and roof materials should match the existing building, and the rules tighten or disappear entirely inside a conservation area or under an Article 4 direction, both of which we check before recommending the route. Where a previous owner has already extended into the roof or added a large outbuilding, the remaining volume allowance can be smaller than expected, so we always confirm the running total against your specific property rather than assuming the full allowance is still available.

Typical hip-to-gable loft conversion drawing packages
Conversion	Typical route	Structural scope	Fee from
Hip-to-gable only	Permitted development / LDC	New gable wall and rafter tie-in	£1,300
Hip-to-gable plus rear dormer	Permitted development / LDC where eligible	Gable wall plus dormer structure	£1,450
Hip-to-gable in a conservation area	Householder planning	New gable wall and rafter tie-in	£1,600

Also in Greenford UB6

Planning Permission Planning Drawings Architectural Drawings Building Regulations Drawings Loft Conversion Drawings Hip-to-Gable Loft Conversion Drawings across Ealing Hip-to-Gable Loft Conversion Drawings across London

FAQ

Hip-to-Gable Loft Conversion Drawings in Greenford UB6 — FAQs

How much do hip-to-gable loft conversion drawings cost in London?+

A hip-to-gable conversion on its own typically starts around £1,300. Combining it with a rear dormer usually costs a little more, around £1,450, to cover the additional structural design — we confirm the fixed fee once we have surveyed your roof.

Will my semi-detached house qualify for permitted development?+

Often, but it depends on the volume already used, whether the property sits in a conservation area or under an Article 4 direction, and whether previous extensions have already used up the allowance. We check this free before recommending a route.

How long do hip-to-gable drawings take?+

Typically around 7 days from survey to a full drawing set in your online portal, whether the route is a Lawful Development Certificate or full planning.

Do I need an architect for a hip-to-gable conversion?+

No — as MCIAT-chartered architectural technologists we produce the same council-accepted drawings, with structural calculations coordinated in-house, typically at a lower fee than an architecture practice.

What building regulations apply to a hip-to-gable loft?+

The same core requirements as any loft conversion: a protected stairway or upgraded fire doors, a compliant means-of-escape window, structural calculations for the new gable wall and floor, and insulation upgraded to current Part L standards. We coordinate all of this alongside the planning or Lawful Development Certificate drawings.

Do I need planning permission for a rear extension in Ealing?+

Many Ealing semis and terraces keep permitted development rights for a single-storey rear extension, so a full application isn't always needed. But the borough-wide Article 4 direction on HMO conversions, and conservation areas such as Bedford Park and Pitshanger, remove or restrict those rights in places. We check your address against the designations first and, where it qualifies, confirm permitted development with a Lawful Development Certificate.

What extra control applies in Bedford Park?+

Bedford Park is one of West London's most tightly controlled conservation areas, with detailed control over materials, rooflines, windows and front elevations. A standard permitted-development dormer or cladding change usually won't apply; instead we design to the area's Arts-and-Crafts character and prepare a full householder application with the elevations and materials the council expects — the reliable route to approval there.

How long does Ealing Council take to decide a householder application?+

Ealing determines most householder applications within the statutory eight-week period once they are validated. The commonest cause of delay is a validation query over missing or inconsistent drawings, so we prepare Ealing submissions to the council's validation checklist — correctly scaled existing and proposed plans, elevations and a location plan — to avoid that back-and-forth.

Can you help with a loft conversion on a 1930s Ealing semi?+

Yes. Ealing's Metro-land semis in Perivale, Greenford and Northolt suit hip-to-gable and dormer loft conversions, which frequently qualify as permitted development on semi-detached homes within the volume limits. We confirm eligibility against those limits and any Article 4 or conservation constraint, then produce the planning and building-regulations drawings.

How much do planning drawings cost in Ealing?+

We work to a fixed fee agreed before we start, typically around 30% below an architect's charge for the same council-accepted drawings, with free redraws until Ealing grants approval. The exact figure depends on the project — a single-storey rear extension differs from a double-storey or a loft — so we quote once we understand your scheme rather than on an open-ended hourly basis.

Free Fixed Quote

Get your free Greenford planning assessment

Tell us your Greenford (UB6) address and ambition — we'll confirm feasibility, local constraints and a fixed fee within one working day.