New-build and estate housing in the White City regeneration area W12, London Borough of Hammersmith and Fulham

White City · W12 · Hammersmith & Fulham

Flat Conversion Drawings in White City W12

Fixed-fee, MCIAT-chartered flat conversion drawings for White City (W12) homeowners — London Borough of Hammersmith & Fulham validation and local constraints handled from the start.

White City (W12) is one of west London's most contrasting districts — the planned interwar Old Oak & Wormholt cottage estate on one side, the vast regeneration of the former BBC and Westfield lands on the other, all in the London Borough of Hammersmith & Fulham. Projects here range from careful roof and rear extensions on the cottage-estate terraces to alterations and fit-outs in the new and converted flats.

The Old Oak & Wormholt conservation area protects the consistent interwar terraces, where roof and frontage changes are sensitive, while the Wood Lane frontage and the White City regeneration framework set the tone for the redevelopment lands. Because so much of the housing is leasehold, alterations often need freeholder consent and party-wall agreement alongside planning, so we establish the property type and any conservation boundary before drawing to Hammersmith & Fulham's guidance.

Proposed floor plan

White City W12

White City (W12) — planning at a glance

Council: London Borough of Hammersmith & Fulham
Postcode district: W12
Planning portal: View the Hammersmith & Fulham planning portal
Housing stock: A district of contrasts — the interwar Old Oak & Wormholt cottage estate and surrounding council-built housing set against the large-scale regeneration of the former BBC and Westfield lands, so the stock spans modest cottage terraces and a growing number of new-build and converted flats.
Article 4: London Borough of Hammersmith & Fulham does not publish its Article 4 directions to the national planning register, so permitted development rights in White City (W12) can’t be confirmed from open data alone — we check the direction schedule with the council before recommending a route, as part of the fixed fee. No householder Article 4 direction is published for W12 White City — the Old Oak & Wormholt and Wood Lane conservation areas, alongside the major regeneration framework, are the defining local controls.
Conservation: Old Oak & WormholtWood LaneShepherds Bush
Sample streets: Bloemfontein Road · Frithville Gardens · Macfarlane Road · Pennard Road
Local constraints: Old Oak & Wormholt conservation area protecting the planned interwar cottage estate, whose consistent terraces are sensitive to roof and frontage alterationWood Lane frontage and the White City regeneration framework shaping expectations for scale and design on the redevelopment landsMix of estate housing and modern leasehold flats, where alterations bring freeholder consent and party-wall considerations distinct from planningShepherds Bush conservation area bleeding in to the south across the W12 boundary

Planning in White City (W12): what to know before you apply

W12 White City has no published householder Article 4 direction, but the Old Oak & Wormholt conservation area protects the interwar cottage estate, where roof and frontage changes are controlled, and the Wood Lane regeneration framework governs the redevelopment lands. Flats and estate housing do not carry the permitted development rights of houses, so much of the alteration work here is assessed as full planning alongside freeholder consent.

Typical White City housing stock

A district of contrasts — the interwar Old Oak & Wormholt cottage estate and surrounding council-built housing set against the large-scale regeneration of the former BBC and Westfield lands, so the stock spans modest cottage terraces and a growing number of new-build and converted flats.

Streets we regularly draw for in White City

Bloemfontein Road · Frithville Gardens · Macfarlane Road · Pennard Road

Flat Conversion Drawings for White City (W12) homes: the package and the process

Every flat conversion drawings we prepare for an White City property is drawn to London Borough of Hammersmith & Fulham’s validation standards and tuned to the W12 constraints above. Here is what the drawing package covers and how the process runs from first survey to approval.

Converting a house into flats is one of the few residential projects in London that always needs planning permission, whatever the size of the property or the number of units created. Splitting a single dwelling into two or more self-contained homes is treated as development regardless of whether any external work is proposed, because the change affects how the building is used and how many households occupy it.

DrawingsDirect draws house-to-flats conversions from the first survey through to a submission-ready planning and building-regulations package. Sound insulation between units, separate escape routes, individual services and London's minimum space standards are designed in from the layout stage, not retrofitted once the council asks for them — which is a large part of why our schemes are approved first time.

Do I need planning permission to convert a house into flats?

Yes, always. Converting a single dwelling into two or more self-contained flats is a change from one home to several, and that subdivision is treated as development requiring a full planning application — there is no permitted development route that allows it, regardless of the property's size or whether the exterior changes at all. The application has to demonstrate that each flat meets space, layout, amenity and parking standards in its own right, not just that the building as a whole is being used sensibly.

Boroughs also weigh the loss of a family-sized house against their local housing policy, since converting a larger house into several flats reduces the stock of homes suited to families even as it adds smaller units. We take that policy context into account when advising on layout and unit numbers, rather than simply maximising the number of flats the floor area could technically support.

What sound insulation is required between flats?

Part E of the building regulations sets minimum sound insulation standards for the walls and floors separating flats, covering both airborne and impact sound. Where an existing house is subdivided, the drawings specify how the party floors and walls between units will be upgraded — additional layers, resilient bars, or a floating floor — and pre-completion sound testing is normally required before the flats can be signed off. Getting this detail right on the drawings from the outset matters, because retrofitting sound insulation after a failed test usually means taking up a finished floor or ceiling that has already been decorated.

House-to-flats conversion drawing packages in London
Conversion	Typical scope	Route	Fee from
House to two self-contained flats	Vertical split, separate or shared entrance	Full planning plus building regulations	£1,600
House to three or more flats	Multiple units, fire strategy required	Full planning plus building regs plus structural	£2,400
Flat conversion with a side or rear extension	Additional floor area added to create compliant units	Full planning plus structural calculations	£2,800

Also in White City W12

Planning Permission Planning Drawings Architectural Drawings Building Regulations Drawings Loft Conversion Drawings Flat Conversion Drawings across Hammersmith & Fulham Flat Conversion Drawings across London

FAQ

Flat Conversion Drawings in White City W12 — FAQs

Do I need planning permission to convert a house into flats?+

Yes, always. Subdividing a single dwelling into two or more self-contained flats is treated as development in its own right, so a full planning application is required regardless of whether the exterior of the building changes.

How much do flat conversion drawings cost in London?+

Packages start from £1,600 for converting a house into two flats and rise to around £2,800 where three or more units, structural work or an extension are involved. We agree a fixed fee once we know the scope.

What sound insulation is required between flats?+

Part E of the building regulations sets minimum airborne and impact sound standards for the floors and walls separating flats, and pre-completion sound testing is normally required before the units can be signed off.

Does each flat need a separate fire escape?+

Each flat needs its own means of escape and the building needs to be fire-compartmented between units, using fire-rated floors, walls and doors and either a protected shared stairway or separate final exits.

What is the minimum size for a flat in London?+

London applies minimum internal floor areas based on bedroom and occupancy numbers, adopted from the national space standards through the London Plan. We check every proposed flat against the relevant threshold before drawing the layout.

Do I need planning permission for a side-return extension in Hammersmith & Fulham?+

On the Victorian and Edwardian terraces of Fulham and Shepherd's Bush a single-storey side-return or rear extension can fall within permitted development, so a full application isn't always required. Conservation areas across Fulham, Brackenbury and Ravenscourt Park, and the Peterborough Estate, restrict this. We check your street's designation first and can confirm permitted development with a Lawful Development Certificate.

Will I need a Basement Impact Assessment for a basement in Hammersmith & Fulham?+

Likely, yes. The council applies a basement policy requiring a basement impact assessment for below-ground works, covering structural stability, drainage and groundwater. Basement extensions are common on these terraces, so if you are considering one we flag the requirement early and coordinate the structural input so the application is complete when submitted.

What is special about the Peterborough Estate 'Lion houses'?+

The Peterborough Estate's distinctive red-brick 'Lion houses' carry strong conservation control over their external character, so alterations are expected to respect the estate's materials and detailing. We design to that character and prepare a full householder application where permitted development doesn't apply, which is the reliable route to approval there.

How long does Hammersmith & Fulham take to decide?+

The council determines most householder applications within the statutory eight-week period once validated; basement and conservation cases can involve additional consultation. Because the terraces are party-wall-sensitive, we prepare submissions to the borough's residential extension and basement guidance to avoid the drawing queries that cause most delays.

How much do planning drawings cost in Hammersmith & Fulham?+

We agree a fixed fee before we start, typically around 30% below an architect's fee for the same council-accepted drawings, with free redraws until the council approves. A side-return, a loft and a basement differ in complexity, so we quote once we have seen your address and project rather than by the hour.

Free Fixed Quote

Get your free White City planning assessment

Tell us your White City (W12) address and ambition — we'll confirm feasibility, local constraints and a fixed fee within one working day.